#Iomega zip 100 device driver windows xp how to#
How to enter and exit the BIOS or CMOS setup.Then, as the computer is booting, enter the BIOS setup.
#Iomega zip 100 device driver windows xp install#
After you install your drive, turn on your computer.
We do not recommend you connect all the cables yet because if there are issues, you may have to disconnect them again.Īs with any IDE/EIDE device, a Zip drive must be properly configured in your computer's BIOS. BIOS setupĪfter connecting the Zip Drive, replace the case back and connect the keyboard, monitor, and power to the computer. This cable is often keyed and only goes in one direction. When connecting the IDE/EIDE cable to the back of the Zip drive, connect the power cable to the back of the drive. It should connect with the colored side of the cable facing the power connection. Often, the red or blue side of the cable represents PIN 1. Once the Zip disk drive has been installed into the computer, connect the IDE/EIDE interface cable to the back of the zip drive. The front bezel is only obtainable through the computer manufacturer.įor links to many computer and hardware manufacturers, see our support listing. Visit a local computer store for alternate brackets.Contact the computer manufacturer for drive brackets compatible with your computer.If your computer does not accept the drive bracket, you may want to consider any of the below recommendations. Drive brackets are included with the internal zip disk drive package. If no 3.5-inch drive bay is available, the computer needs a drive bracket and partial front bezel to cover the empty portion. Drive baysĪn internal zip drive is always going to occupy or need a 3.5-inch drive bay. The Zip drive is set as the secondary device. When installing the IDE/EIDE zip drive ensure that the Zip drive has the proper jumper setting. When physically installing the zip disk drive, ensure the computer is powered down and unplugged.Ensure you are familiar with ESD and its potential dangers.Write down important information from the top or bottom of the hard drive, such as the model number, serial number, and its specifications.Updated: by Computer Hope Before getting started
0 kommentar(er)
